大家好，最近車間事情比較多，一是因為車間都是老設備，二是因為新工人還沒有完全熟悉，對設備操作不熟練，容易出現操作失誤，從而導致設備故障，第三就是雨季來了，工人對設備缺乏呵護，造成設備故障頻發；最後的一個原因就是受國際疫情影響，國內工人過不來，現場人手比較緊張，所以造成經常加班，有時是領導安排，有時時車間Forman給打電話，總之，又要加班.
How are you ,everyone.the workshop have plenty of jobs rencently, of course ,there are some objective reasons as well as subjective excuses.fristly,there are old and shabby equipmemts,secondly,the new employee /workers are not familar with the old and renewed facilites at the moment,although they have been trained for one or two weeks ,but the effects of trainning is very negtive ,the new recuit do not fully understand /grasp the main/important expertise ,they are vugar for workshop ,be afraid of being confused by complicated trainning as a apprentice/trainee.if it looks like this effect ,not proficient for his position and operation,easy to evolve into instances,and causing failure of equipments, thridly,now it is rainning season ,the local is not resposible for his duties on work ,became derelict/negligent of his duties ,just stay at operator room ,seating and playing games in their smart phone.so make it easy to hance the frequencies of equipments failure, but the last reason is that international phneumonia virus ,the domestic chinese can not come to this country,so the workpower is lack/short/scarce of requirement,it means that our chinese singlelatral energy is very compact and limited/infinite,so offen asked us to work overtime,sometime it is requirment of boss,sometime it is called by local forman,generally,work overtime again.
昨天下午當地時間剛吃飯，領導打電話，說車間設備無法啟動了，趕緊穿上工作服，走著就去了，順便說一句，走著去至少要16分鐘，而且出一身汗，等過去之後，發現，不是設備無法啟動而是設備固定螺栓鬆動厲害，電機電動非常厲害，因此車間操作工人停了設備向領導彙報。這個固定當時鉗工沒有固定好，導致振動一段時間（大約一週）後，螺絲鬆動，出現振動，再一個，螺絲的質量也有一定的問題，強度不夠，螺母易鬆動。等緊完之後，啟動設備，測量電流，電流正常，後回去接著吃飯，此時飯已經涼透了，打工不易啊。
I was at dinner yersterday afternoon when knocked off the work,suddenly ,boss called me one equipmemt shut down ,need to have a check,so i rechanged my workwear and high cut shoes ,walking to my deatination straightly without any honver/hesitation on the road,by the way,it would take your one quarter hour to arrive at that place.but if you seleted a vechile,just need a few minutes totaily.i got full body sweat when i went there .i found that motor coubld be rebooted/started very well.the only question was that the bolts used to fastened foundation of motor were slack/loose ,the vibration of motor was very serious and rampant/arrogant ,so the operators reported to boss.if the fitters fastened well at the begninning ,it did not happen that day .meanwhile the bolts qualities are not strong enough so that it could not resist /boycott/countersct the vibration ,so it was easy to causing the bolts loose/slack. after finished fastening ,restarted motor ,it procured success ,test current it was right. went back to go on with my dinner but it has been cool fully,who did care your dinner ,it is hard to kind employee
可是 ，到9點左右，領導又打來電話，說跳停了，給值班電工打電話打不通（小夜和r大夜就兩個電工，無後補電工，正好趕上休班，所以沒有值班電工），於是我又去了，合上閘之後，剛啟動運行，又跳了，於是先排查電機、再檢查電纜是否損傷，由於兩個電機是並聯的，必須把兩個電機的電纜都拆除才能測絕緣，經過檢查，電機是好的，於是把問題鎖定在電纜，順著電纜檢查電纜，共發現兩處電纜損傷，一是被焊工的焊渣把電纜燒損，而是在電機的接線盒接口附近，電纜接地，造成短路，經處理後，電機可正常啟動且電流合適。
But ,let me unfortunately ,the phone was hanging/ringing again.that equipment tripped off ,he called shift electrician but no body answered (both of shift electricians taking dayoff) .so i was ordered to go/initiate/launch journey/tour. when i turned on /switch power again ,started motor,it would trip off the circuit breaker again.so i stopped my job to check the motor and cable along the cable tray.disconnected cables from motor termination as well as testing the insulation value of motors ,it was good with no problems left.i checked the cable along the cable tray. luckly, i found one place that the rubber burnt already ,touching ground ,another broken place of cable was located at the input of motor termination ,one cable core has broken by the friction of vibration ,causing short between cable and ground ,so there were two radical causes locked by me ,i repacked the broken places and cutoff broken cable core ,connect wires to motors again ,restarted motors ,it was working verywell.and testing current of motors while running ,it was normal
令人感到惱怒的是，那天晚上又下著雨，又帶著眼睛，又出汗，影響視力而且電纜在暗處又不好排查，累壞了，一個小小的故障，硬是整了3個半小時才搞定，回到宿舍快凌晨一點了，洗洗後趕緊睡覺了，朋友們，做為工人都不容易啊，你有同樣的經歷嗎？我相信一定有，如果你有同感，記得關注，轉發，謝謝！
Making me thrilled/upset/incensed ,it was also rainning all the time while i fixed that problems.i wore myopic eyes glasses plus sweating all the time,so the inclement weather affected my eyesight/vision/view,and the bulky lights was gloomy /dim ,it was hazy/blury so that hard to find out the problems .so it took me three and half hour to solve/resolve/handle /deal with /cope with/tackle it,after finishing ,i was very tried /out of energy/power/strangth.i run out of power/i depleted my strangth.went back to camproom,engaging a simple/brief/concise/quick/prompt/swift/rapaid shower as soon as possible.going sleeping.
So ,my dear/genial/honest/sincere/genunen friends,we are hard/tough to face daily working,do you experience the courses of working stages ?i confrim/certainfy that you must do it ,so please remember to foucs on me ,and forwarding my articles ,thanks a lot
閱讀更多 七分雨彩虹橋 的文章
